Hyundai Genesis (DH): Heating, Ventilation and Air Conditioning / Air Conditioning System
- General Safety Information and Caution
- Description and Operation
- Repair procedures
- Components and Components Location
- Compressor oil Repair procedures
- Refrigerant Line Repair procedures
- Compressor Description and Operation
- Compressor Components and Components Location
- Compressor Repair procedures
- Condenser Repair procedures
- Receiver-Drier Repair procedures
- A/C Pressure Transducer Description and Operation
- A/C Pressure Transducer Repair procedures
- Evaporator Temperature Sensor Description and Operation
- Evaporator Temperature Sensor Repair procedures
- In-car Sensor Description and Operation
- In-car Sensor Repair procedures
- Photo Sensor Description and Operation
- Photo Sensor Repair procedures
- Ambient Temperature Sensor Description and Operation
- Ambient Temperature Sensor Repair procedures
- CO2 Sensor Description and Operation
- CO2 Sensor Schematic Diagrams
- CO2 Sensor Repair procedures
- Auto Defogging Sensor Description and Operation
- Auto Defogging Sensor Repair procedures
- Cluster Ionizer Description and Operation
- Cluster Ionizer Repair procedures
Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.
Instructions When Handling Refrigerant 1. R-134a liquid refrigerant is highly volatile. A drop on the skin of your hand could result in localized frostbite.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Repair procedures
Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal.
Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Restraint
- Body Electrical System
- Engine Mechanical System
- New on site
- Most important about car
