Hyundai Genesis: Air Conditioning System / Ambient Temperature Sensor Repair procedures

Inspection

1.

Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature. 1. Ambient Sensor (+) 2. Sensor ground Specification Ambient temperature [°C(°F)] Resistance between terminal 1 and 2 (k?) -30 (-22) 547.35 -20 (-4) 297.66 -10 (14) 168.61 0 (32) 99.07 10 (50) 60.05 20 (68) 37.54 30 (86) 24.13 40 (104) 15.19 50 (122) 10.74

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper. (Refer to Body - "Outside Rear View Mirror")

3.	Loosen the screws securing the ambient temperature sensor.

4.	Push upward the ball (B) in the lower side while lifting up the two clips (A).

5.	Disconnect the connector, then remove the ambient temperature sensor.

6.	Install in the reverse order of removal.

Ambient Temperature Sensor Description and Operation

Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperatu ...

CO2 Sensor Description and Operation

Description This system maintains the density of carbon dioxide constantly in vehicle interior by measuring the amount of carbon dioxide to increase the comfortableness and the fuel consumptio ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: LKAS malfunction

If there is a problem with the system a message will appear for 2 seconds. If the problem continues the LKAS failure indicator will illuminate. LKAS failure indicator The LKAS failure indicator (yellow) will illuminate if the LKAS is not working properly. Have your vehicle checked ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Filler Door Open Switch Repair procedures

Inspection 1. Disconnect the battery(-) terminals. 2. Remove the crash pad Lower panel. 3. Disengage the retaining clips and remove the crash pad lower panel switch (A). 4. Remove the leostat switch connector. 5. Check the switch for continuity between the terminals. ...