| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Disconnect the connector and then remove the auto defogging sensor (A).
|
| 3. |
Install in the reverse order of removal. |
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging.
Description The cluster ionizer disinfects and decomposes bad smell from the air-conditioner or inflow air in order to clean the indoor air of a vehicle.
Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.