Hyundai Genesis (DH): Air Conditioning System / Auto Defogging Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Auto Defogging Sensor Description and Operation
| Description |
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad under cover [RH]. (Refer to Body - "Crash Pad Under Cover") 3.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector and then remove the auto defogging sensor (A). 3. Install in the reverse order of removal.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Electric Parking Brake (EPB) Repair procedures
- Brake System
- Suspension System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0308