Other information:
Inspection
1.
Remove the overhead console lamp assembly and check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the ...
Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt idler (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
3.
To install, reverse the removal procedure.
Inspection
Drive belt, Idler, ...