Hyundai Genesis (DH): Emission Control System / Evaporative Emission Control System

Removal 1. Disconnect the vapor hose (A). 2. Remove the rubber pad (B), and then remove the PCV valve. Inspection 1. Insert a thin stick (A) into the PCV valve (B) of the threaded side to check that the plunger moves.

Schematic Diagram

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation

Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,

Categories

 
Copyright В© 2026 www.hgenesisdh.com - 0.0259