Hyundai Genesis (DH): Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Emission Control System / Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Removal
1.
Disconnect the vapor hose (A).
2.
Remove the rubber pad (B), and then remove the PCV valve.

Inspection
1.
Insert a thin stick (A) into the PCV valve (B) of the threaded side to check that the plunger moves.

   
If the plunger does not move (PCV valve is clogged), clean or replace the valve.
Installation
1.
To install, reverse the removal procedure.
PCV Valve installation:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

    Operation Principle

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0336