Hyundai Genesis (DH): Emission Control System
- General Information
- Description and Operation
- Specifications
- Troubleshooting
- Components and Components Location
- Schematic Diagrams
- Crankcase Emission Control System
- Schematic Diagrams
- Repair procedures
- Positive Crankcase Ventilation (PCV) Valve Description and Operation
- Positive Crankcase Ventilation (PCV) Valve Repair procedures
- Evaporative Emission Control System
- Schematic Diagrams
- Repair procedures
- Canister Repair procedures
- Fuel Filler Cap Description and Operation
- Fuel Tank Air Filter Repair procedures
- Exhaust Emission Control System
Inspection [Measuring Resistance] 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Brake System
- 4 Wheel Drive (AWD) System
- New on site
- Most important about car
