| Replacement |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the canister assembly.
(Refer to Evaporative Emission Control System - "Canister") |
| 3. |
Loosen the installing bolt (A). |
| 4. |
Remove the fuel tank air filter after disconnecting the vapor hose (B).
|
| 5. |
Remove the canister close valve from the fuel tank air filter.
(Refer to Engine Control System - "Canister Close Valve") |
| 6. |
Install a new fuel tank air filter. |
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler.
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.