Hyundai Genesis (DH): Air Conditioning System / Auto Defogging Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Auto Defogging Sensor Description and Operation
| Description |
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad under cover [RH]. (Refer to Body - "Crash Pad Under Cover") 3.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector and then remove the auto defogging sensor (A). 3. Install in the reverse order of removal.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Brake System
- Electric Parking Brake (EPB) Repair procedures
- Starter Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0208