Hyundai Genesis (DH): 4 Wheel Drive (AWD) System
Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System
- General Information
- Transfer Assembly
- Transfer Case Assembly Components and Components Location
- Transfer Case Assembly Repair procedures
- Transfer Fluid Specifications
- Transfer Fluid Repair procedures
- Front Axle Flange Repair procedures
- Rear Axle Flange Repair procedures
- O-Ring Radial Repair procedures
- Seal Ring Radial Repair procedures
- AWD Control System
Removal 1. Remove the nut (B) and clip (C). 2. Remove the shift cable (A) assembly from the transmission. Tightening torque : 12.7 ~ 15.7 N.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Hyundai Genesis (DH) 2013-2016 Service Manual: Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Electric Parking Brake (EPB) Repair procedures
- Starter Repair procedures
- Body Electrical System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.028