Hyundai Genesis (DH): Air Conditioning System / Receiver-Drier Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Receiver-Drier Repair procedures

Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with the L wrench (A).

Tightening torque :
9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
3.
Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.

4.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
5.
Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.
6.
Install a new bottom cap to the condenser.
   

    Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers.

    Description The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    C

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0295