Hyundai Genesis (DH): Air Conditioning System / A/C Pressure Transducer Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Description and Operation

Description
The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system.

    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.

    Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminal

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.025