Hyundai Genesis (DH): 4 Wheel Drive (AWD) System / Transfer Assembly
Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System / Transfer Assembly
- Transfer Case Assembly Components and Components Location
- Transfer Case Assembly Repair procedures
- Transfer Fluid Specifications
- Transfer Fluid Repair procedures
- Front Axle Flange Repair procedures
- Rear Axle Flange Repair procedures
- O-Ring Radial Repair procedures
- Seal Ring Radial Repair procedures
Adjustment Introduction It is necessary to check and input the calibration data when the controller is replaced as the characteristics of the internal frictional materials (clutch pack) change due to driving.
Components Location 1. Engine2. Transmission3. Rear differential4. Rear propeller shaft5. Transfer case6. Front propeller shaft7. Front differential
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Components and Components Location
C
Hyundai Genesis (DH) 2013-2016 Service Manual: Ambient Temperature Sensor Description and Operation
Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control,
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- General Information
- Engine Electrical System
- Active Air Flap(AAF) Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0242