Hyundai Genesis (DH): Transfer Assembly / Transfer Fluid Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System / Transfer Assembly / Transfer Fluid Repair procedures

Inspection
   
Prohibition on checking, refilling and replacing the transfer case oil
-
Do not check, refill and replace the transfer case oil because the oil for the transfer case only (ultra-low viscosity of ATF SHELL TF 0870) is filled when coming out of the factory.
-
Do not check and replace the oil.
-
No drain plug
-
In case that the transfer case (AWD) oil-related failure code (DTC) appears, replace the transfer oil case assembly.

    Lubricant ItemDefined lubricantCapacityTransfer oilOil for the transfer case onlyUltra low viscosity of ATF SHELL TF08700.620L(0.165 U.S gal., 0.66 U.

    Removal     Use caution when handling the transfer case. Preventing the ITA (Integrated Transfer case Actuator ) from damage 1) In case of transporting the transfer case

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0261