| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the mirror wiring cover (A) and rain sensor cover (B).
|
| 3. |
Remove the LKAS unit connector (A).
|
| 4. |
Remove the LKAS unit after disengaging the mounting bracket (A).
|
| Installation |
| 1. |
Partially install the LKAS unit by aligning the windshield bracket points (A) to the unit.
|
| 2. |
To completely install the unit, push the unit towards the tightening point (B).
|
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.