Hyundai Genesis (DH): AWD Control System / AWD ECU Schematic Diagrams
Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System / AWD Control System / AWD ECU Schematic Diagrams
| Circuit diagram |
| AWD ECU connector |
| AWD ECU terminal function |
| 1 | Motor electric power |
| 2 | Ground connection |
| 3 | Ignition |
| 4 | - |
| 5 | - |
| 6 | CAN high |
| 7 | CAN low |
| 8 | Electric power supply controller |
AWD ECU input/output diagram
Removal 1. IG Key "ON". 2. Connect the GDS in the vehicle. 3. To read the transfer case data in old ITA(ECU), select "ECU Data Back-up & Writing" service of GDS.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.
Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Brake System
- Steering System
- Heating, Ventilation and Air Conditioning
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0235