Hyundai Genesis (DH): Body Electrical System / Lighting System
- Specifications
- Components and Components Location
- Head Lamps Components and Components Location
- Head Lamps Description and Operation
- Head Lamps Repair procedures
- Door Mirror Lamp Repair procedures
- Room Lamp Repair procedures
- Overhead Console Lamp Repair procedures
- Door Mood Lamp Repair procedures
- Hazard Lamp Switch Repair procedures
- Rheostat Components and Components Location
- Rheostat Repair procedures
- Front Fog Lamps Repair procedures
- License Lamps Repair procedures
- High Mounted Stop Lamp Repair procedures
- Rear Combination Lamp Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the panorama sunroof motor (A) after loosening the screws and disconnecting the connector.
Specification ItemBulb TypeBulb Wattage (W)FrontHead lamp (Halogen)LowH1155HighHB360Head lamp (HID)LowD1S35HighBI-Function-Front turn signal lampLED / PY28WLED / 28Position lampLEDLEDFront fog lampLEDLEDDoor mirror turn signal lampLEDLEDRearHigh mounted stop lampLEDLEDTurn signal lamp28/8W NA / LED28 / LEDRear stop/tail lamp (Outside)LEDLEDRear stop/tail lamp (Inside)LEDLEDBack up lampW16W / LED16 / LEDLicense plate lampLEDLEDInteriorLuggage lampLEDLEDMap LampLEDLEDRoom LampLEDLEDVanity LampLEDLED
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Components and Components Location
- Emission Control System
- Parking Assist Sensor Repair procedures
- New on site
- Most important about car
