| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Separate the room lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| 3. |
Separate the makeup lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| Installation |
| 1. |
Install the lamp assembly after connecting the lamp connector. |
| 2. |
Connect the negative (-) battery terminal. |
Removal Puddle Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside mirror assembly. Be careful not to damage the pin-type retainer 3.
Inspection 1. Remove the overhead console lamp assembly and check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.
Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal.
Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.