Hyundai Genesis: Driveshaft and axle

AWD ECU Repair procedures
Removal 1. IG Key "ON". 2. Connect the GDS in the vehicle. 3. To read the transfer case data in old ITA(ECU), select "ECU Data Back-up & Writing" service of GDS. 4. IG key "OFF". ...

General Information
...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Steering Angle Sensor Repair procedures


Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of an absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed in the following cases: - Replacement of the Steering Wheel Angle Speed Sensor - ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Control Module (ECM) Schematic Diagrams


ECM Terminal and Input/Output signal ECM Terminal Function Connector [E100-A] Pin No.DescriptionConnected to1-?2-?3-?4-5Power groundChassis Ground6Power groundChassis Ground7-?8-?92nd CAN [High]Multi-Purpose Check Connector10CAN [High]Other control module, Data Link Connector (DLC), Multi-P ...

© 2013-2022 www.hgenesisdh.com