Hyundai Genesis (DH): Engine Electrical System / Charging System
- Description and Operation
- Repair procedures
- Alternator Description and Operation
- Alternator Specifications
- Alternator Schematic Diagrams
- Alternator Repair procedures
- Battery Description and Operation
- Battery Specifications
- Battery Repair procedures
- Battery Troubleshooting
- Battery Sensor Description and Operation
- Battery Sensor Repair procedures
Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm for 3 minutes or longer. 2. Remove the spark plug. 3. Check the spark plug visually.
Description The charging system includes a battery, an alternator with a built-in regulator, and the charging indicator light and wire. The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- General Information
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- Body Electrical System
- New on site
- Most important about car
