| Description |

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the engine cover. 3. Disconnect the alternator connector (A) and cable (B) from the 'B' terminal.
Specifications ?AGM105L-DIN ItemSpecificationModel typeAGM105L-DIN Cold Cranking Amperage (A)950 (SAE) / 760 (EN) Reserve Capacity (Min)190
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.