Hyundai Genesis: Charging System / Alternator Description and Operation

Description
The Alternator has built-in diodes, each rectifying AC current to DC current, to supply DC current to the alternator “B” terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. Drive belt pulley
3. Stator
4. Rotor

Repair procedures
On-vehicle Inspection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

Alternator Specifications
Specification ItemSpecificationRated voltage13.5V , 150ASpeed in use1,500 ~ 18,000rpmVoltage regulatorIC Regulator built in typeRegulator reform mode voltage (V) [COM terminal]14.0 ~ 15.5 (-35°C ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Curtain Airbag (CAB) Module Repair procedures


Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the curtain airbag harness connector. 4. After loosening the mounting bolts remove the curta ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location


Components 1. Water pump pulley2. Water pump3. Water pump gasket4. Water center pipe5. Water inlet pipe6. Water outlet pipe7. Water temperature control assembly8. Thermostat ...

© 2013-2025 www.hgenesisdh.com