| Specification |
| Item | Specification |
| Rated voltage | 13.5V , 150A |
| Speed in use | 1,500 ~ 18,000rpm |
| Voltage regulator | IC Regulator built in type |
| Regulator reform mode voltage (V) [COM terminal] | 14.0 ~ 15.5 (-35 |
Description The Alternator has built-in diodes, each rectifying AC current to DC current, to supply DC current to the alternator
Circuit Diagram
Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.