Other information:
Adjustment
Introduction
It is necessary to check and input the calibration data when
the controller is replaced as the characteristics of the internal
frictional materials (clutch pack) change due to driving.
Creation condition and calibration method
1.
In case of replacing the transfe ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front/rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector (B) from the parking assist sensor (A).
4.
Remove the sensor (A) by pulling out b ...