Hyundai Genesis (DH): Intake And Exhaust System / Exhaust Manifold Components and Components Location
| Components |
| 1. LH Gasket 2. LH Exhaust manifold 3. RH Exhaust manifold stay | 4. RH Gasket 5. RH Exhaust manifold 6. RH Exhaust manifold stay |
Removal and Installation 1. Remove the surge tank. (Refer to Intake and Exhaust System - "Surge Tank") 2. Remove the breather pipe & hose (A).
Removal and Installation LH Exhaust Manifold 1. Disconnect the battery "-" terminal from the trunk room. 2. Loosen the drain plug and drain the engine coolant.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Mechanical System
- ECS-G Sensor Repair procedures
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- New on site
- Most important about car
