| Replacement |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the canister assembly.
(Refer to Evaporative Emission Control System - "Canister") |
| 3. |
Loosen the installing bolt (A). |
| 4. |
Remove the fuel tank air filter after disconnecting the vapor hose (B).
|
| 5. |
Remove the canister close valve from the fuel tank air filter.
(Refer to Engine Control System - "Canister Close Valve") |
| 6. |
Install a new fuel tank air filter. |
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler.
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.