Hyundai Genesis: Rear Bumper / Rear Bumper Beam Assembly Components and Components Location

Component Location

1. Rear bumper beam assembly

Rear Bumper Cover Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape aroun ...

Rear Bumper Beam Assembly Repair procedures

Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Knock Sensor (KS) Repair procedures

Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the installation bolt (A), and then remove the sensor from the cylinder block. [Knock Sensor #2 (Bank 2)] 1 ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Power outlet

The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 180 W(Watt) with the engine running. To open the cover, press the cover and it will slowly open. To close the c ...