Hyundai Genesis (DH): Lubrication System / Oil Level Gauge & Pipe Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe Repair procedures

Removal and Installation
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the engine room cover and the radiator grill upper cover.
(Refer to Engine And Transaxle Assembly - "Engine Cover")
4.
Remove the oil level gauge.
5.
Remove the water outlet pipe & hose (B) and then oil level gauge rod (A).
Tightening torque
19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 Ib-ft)

   

    Components 1. Engine oil level gauge2. Engine oil level gauge rod

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Description and Operation

    Description An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signa

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0236