Hyundai Genesis (DH): Suspension System / Rear Suspension System
- Components and Components Location
- Rear Shock Absorber Components and Components Location
- Rear Shock Absorber Repair procedures
- Rear Upper Arm Repair procedures
- Rear Assist Arm Repair procedures
- Trailing Arm Repair procedures
- Rear Lower Arm Repair procedures
- Rear Cross Member Repair procedures
- Rear Stabilizer Bar Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub.
Components Location 1. Rear shock absorber2. Rear upper arm rear 3. Rear trailing arm4. Rear assist arm5. Rear sub frame6. Rear upper arm front7. Rear stabilizer bar8.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Repair procedures
Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Emission Control System
- Suspension System
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- New on site
- Most important about car
