Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. To remove the front door outside handle base connector (A), widen both sides of the wiring fastener (A) and then push back the front door outside handle base connector.
Components 1. Rear door inside handle cap2. Rear door pull cap3. Rear door trim4. Rear door frame inner cover 5. Rear door module6. Rear door latch assembly7.
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.