Hyundai Genesis (DH): Front Door / Front Door Latch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Repair procedures

Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
To remove the front door outside handle base connector (A), widen both sides of the wiring fastener (A) and then push back the front door outside handle base connector.

3.
Loosen the front door regulator module mounting bolt.

4.
Disconnect the front door latch connector (A).
5.
Remove the front door latch assembly (B) by pulling it in the direction of the arrow.

6.
Disconnect the front door inside handle cage and then remove the cable by pushing it rearward.
7.
Disconnect the front door outside the front door handle cable (A) and then remove the support bracket (B).

8.
Install in the reverse order of removal.
   

    Replacement 1. Loosen the front door checker (B) mounting bolt. 2. Detach the clips, then remove the front door side weatherstrip (A). Tightening torque : 16.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0238