Hyundai Genesis (DH): Front Door / Front Door Side Weatherstrip Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Side Weatherstrip Repair procedures

Replacement
1.
Loosen the front door checker (B) mounting bolt.
2.
Detach the clips, then remove the front door side weatherstrip (A).
Tightening torque :
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)

3.
Install in the reverse order of removal.
   

    Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

    Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. To remove the front door outside handle base connector (A), widen both sides of the wiring fastener (A) and then push back the front door outside handle base connector.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation

    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0498