Hyundai Genesis (DH): Air Conditioning System / Compressor Repair procedures

Removal
1.
If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
2.
Disconnect the negative (-) battery terminal.
3.
Remove the engine room cover.
(Refer to Engine Mechanical System - "Engine room cover")
4.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
5.
Recover the refrigerant with a recovery/charging station.
6.
Remove the engine room under cover (A).

7.
Loosen the drive belt.
(Refer to Engine Mechanical System - "Timing System")
8.
Remove the bolts, then disconnect the suction line (A) and discharge line (B) from the compressor.

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

   
Plug or cap the lines immediately after disconnecting them to avoid the intrusion of moisture and dust.
9.
Disconnect the compressor switch connector (A).

10.
Remove the compressor (A) by loosening the mounting bolts.
[Lambda Engine]

[Tau Engine]

Installation
1.
Make sure the compressor mounting bolt with the correct length is screwed in. Tighten the mounting bolts in the specified tightening order.

Tightening torque :
20.00~32.95 N.m (2.04~3.36 kgf.m, 14.75~24.30 lb-ft)

[Lambda Engine]

[Tau Engine]

2.
Install in the reverse order of removal.
   

    Components [Lambda Engine] 1. Center Bolt2. Hub Bolt3. Limiter & Damper Assembly4. Snap Ring5. Pulley6. Compressor Assembly [Tau Engine] 1.

    Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Components and Components Location

    C

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description Control Function This system supports 2 kinds of main function. (Rear video display function, Expected trace of wheels display function) The Rear video display and the expected trace of wheels display operate according to Vehicle speed condition and Gear position.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.033