Hyundai Genesis (DH): Rear Door / Rear Door Window Glass Repair procedures

Replacement
1.
Pull down rear door window glass by pressing the power window glass switch.
2.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
3.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).

4.
After loosening the mounting screws, remove the rear door delta garnish (A).

5.
Completely loosen the rear door channel mounting bolt and unscrew the nuts as loosely as possible without the nuts removed from the rear door panel.

Tightening torque :
Bolt : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

6.
Slightly push the rear door channel in the direction of arrow as below.

7.
Remove the rear door window glass mounting hole plug (A).Loosen the rear delta lower channel (C) mounting bolts.

8.
Carefully adjust the rear door window glass (A) until you can see the bolt, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

   

    Component Location 1. Rear door window glass

    Component Location 1. Rear door module

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: LKAS Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror wiring cover (A) and rain sensor cover (B). 3. Remove the LKAS unit connector (A). 4. Remove the LKAS unit after disengaging the mounting bracket (A). Installation 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures

    Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0193