Hyundai Genesis (DH): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly Components and Components Location
- Hood Assembly Repair procedures
- Hood Lifter Repair procedures
- Hood Insulator Pad Repair procedures
- Hood Seal Weatherstrip Repair procedures
- Hood Latch Release Handle Components and Components Location
- Hood Latch Release Handle Repair procedures
- Hood Latch Components and Components Location
- Hood Latch Repair procedures
Replacement
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Body Electrical System
- Body (Interior and Exterior)
- Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0354