Hyundai Genesis: Hood / Hood Seal Weatherstrip Repair procedures

Replacement

1.	Remove the hood seal weatherstrip (A) and then remove the clip from the panel. • Be careful not to scratch the hood seal weatherstrip.

2.	Install in the reverse order of removal. • Replace any damaged clips. • When installing, put a clip in the strip, install hood seal weatherstrip on a panel.

Hood Insulator Pad Repair procedures

Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Install in the revers ...

Hood Latch Release Handle Components and Components Location

Component Location 1. Hood latch release handle ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: 4&OD Clutch Control Solenoid Valve Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4. Check that the resistance is within the specification. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

Components 1. Front pillar trim2. Cowl side trim3. Front door scuff trim4. Front door step trim5. Center pillar upper trim6. Center pillar lower trim 7. Rear door scuff trim8. Rear door step trim9. Rear wheel house trim10. Rear pillar trim11. Rear package tray trim ...