Hyundai Genesis (DH): Hood / Hood Latch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement
1.
Remove the front bumper.
(Refer to Front bumper - "Front bumper cover")
2.
Remove the active air flap (AAF).
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
3.
Disconnect the connector (A), then remove the wiring fastener.

4.
Remove the hood latch (A) mounting bolts and pin-type retainers.

5.
Disconnect the hood latch cable (A) and remove the hood lower latch assembly (B).

6.
Install in the reverse order of removal.
   

    Component Location 1. Hood latch assembly

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.024