Hyundai Genesis (DH): Body (Interior and Exterior) / Trunk Lid
- Repair procedures
- Trunk Lid Assembly Components and Components Location
- Trunk Lid Assembly Repair procedures
- Trunk Lid Trim Components and Components Location
- Trunk Lid Trim Repair procedures
- Trunk Lid Key Holder Repair procedures
- Trunk Lid Back Panel Components and Components Location
- Trunk Lid Back Panel Repair procedures
- Trunk Lid Weatherstrip Repair procedures
Replacement 1. Remove the front bumper. (Refer to Front bumper - "Front bumper cover") 2. Remove the active air flap (AAF). (Refer to Engine Mechanical System - "Active Air Flap(AAF)") 3.
Adjustment 1. Place the car on a flat surface and check whether the body and trunk lid are well-aligned. 2. After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up and down or from side to side.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Body Electrical System
- Components and Components Location
- Engine Mechanical System
- New on site
- Most important about car
