Hyundai Genesis (DH): Hood / Hood Latch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement
1.
Remove the front bumper.
(Refer to Front bumper - "Front bumper cover")
2.
Remove the active air flap (AAF).
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
3.
Disconnect the connector (A), then remove the wiring fastener.

4.
Remove the hood latch (A) mounting bolts and pin-type retainers.

5.
Disconnect the hood latch cable (A) and remove the hood lower latch assembly (B).

6.
Install in the reverse order of removal.
   

    Component Location 1. Hood latch assembly

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0236