Hyundai Genesis (DH): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly Components and Components Location
- Hood Assembly Repair procedures
- Hood Lifter Repair procedures
- Hood Insulator Pad Repair procedures
- Hood Seal Weatherstrip Repair procedures
- Hood Latch Release Handle Components and Components Location
- Hood Latch Release Handle Repair procedures
- Hood Latch Components and Components Location
- Hood Latch Repair procedures
Replacement
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- General Information
- Restraint
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0225