| Adjustment |
| 1. |
After loosening the hinge (A) mounting bolt, adjust the hood
(B) by moving it up and down or from side to side and tighten the bolt. |
| 2. |
Adjust the hood height by moving the hood overslam bumpers (C) up and down. |
| 3. |
After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up and down or from side to side.
|
Component Location 1. Hood assembly
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.