Hyundai Genesis (DH): Air Conditioning System / CO2 Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / CO2 Sensor Description and Operation
| Description |
This system maintains the density of carbon dioxide
constantly in vehicle interior by measuring the amount of carbon dioxide
to increase the comfortableness and the fuel consumption rate when air
conditioning system is operating.
| 1. CO2 sensor signal 2. Ground | 3. IG2(12V) |
Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.
Interface Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and Operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Active Air Flap(AAF) Repair procedures
- Emission Control System
- Components and Components Location
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.026