Hyundai Genesis (DH): Body (Interior and Exterior) / Trunk Lid
- Repair procedures
- Trunk Lid Assembly Components and Components Location
- Trunk Lid Assembly Repair procedures
- Trunk Lid Trim Components and Components Location
- Trunk Lid Trim Repair procedures
- Trunk Lid Key Holder Repair procedures
- Trunk Lid Back Panel Components and Components Location
- Trunk Lid Back Panel Repair procedures
- Trunk Lid Weatherstrip Repair procedures
Replacement 1. Remove the front bumper. (Refer to Front bumper - "Front bumper cover") 2. Remove the active air flap (AAF). (Refer to Engine Mechanical System - "Active Air Flap(AAF)") 3.
Adjustment 1. Place the car on a flat surface and check whether the body and trunk lid are well-aligned. 2. After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up and down or from side to side.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Description and Operation
- Engine Mechanical System
- New on site
- Most important about car
