Hyundai Genesis: Hood / Hood Lifter Repair procedures

Replacement

• Removing or installing the hood lifter requires an assistant. • When removing the hood lifter, first remove the lower part and then upper part.

1.	Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B), and then remove the lifter from the bracket.

2.	Push the socket of the lifter into the bracket for installation. • Make sure the hood locks/unlocks and opens/closes properly.

Hood Assembly Repair procedures

Replacement     • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components.     • Removing or insta ...

Hood Insulator Pad Repair procedures

Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Install in the revers ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Ambient Temperature Sensor Repair procedures

Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature. 1. Ambient Sensor (+)2. Sensor ground Specification Ambient temperature [°C(°F)] Resistance between terminal 1 and 2 (k?)-30 (-22)54 ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Assist Arm Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the rear hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     Be careful not to damage the ...