Hyundai Genesis (DH): Brake System / ESC(Electronic Stability Control) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- EBD(Electronic Brake-force Distribution) Description and Operation
- ESC Control Unit Repair procedures
- Emergency Signal System Description and Operation
- Front Wheel Speed Sensor Components and Components Location
- Front Wheel Speed Sensor Repair procedures
- Rear Wheel Speed Sensor Components and Components Location
- Rear Wheel Speed Sensor Repair procedures
- ESC OFF Switch Description and Operation
- ESC OFF Switch Repair procedures
- Steering Angle Sensor Description and Operation
- Steering Angle Sensor Repair procedures
Removal 1. Turn ignition switch off and disconnect the battery (-) cable from the battery 2. Remove the driver side crash pad side cover. (Refer to Body - "Crash Pad") 3.
Components 1. HECU module2. Steering angle sensor (SAS)3. Rear wheel speed sensor4. Front wheel speed sensor
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Steering System
- Engine Mechanical System
- Engine Electrical System
- New on site
- Most important about car
