Hyundai Genesis (DH): Body Electrical System / Blind Spot Detection system
- Specifications
- Components and Components Location
- Description and Operation
- Repair procedures
- Blind Spot Detection Unit Schematic Diagrams
- Blind Spot Detection Unit Repair procedures
- Blind Spot Detection Switch Components and Components Location
- Blind Spot Detection Switch Repair procedures
- Blind Spot Detection Indicator Components and Components Location
- Blind Spot Detection Indicator Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror wiring cover (A) and rain sensor cover (B). 3. Remove the LKAS unit connector (A).
Specifications ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15?/h ~ 250?/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFrequency24 GHzNumbers2EA (Master 1EA, Slave 1EA)
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Restraint
- Starter Repair procedures
- Engine Mechanical System
- New on site
- Most important about car
