Other information:
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the Engine room fuse & relay box (B) after removing the cover (A).
3.
Disconnect the brake tubes (A) from the HECU by unlocking the nuts counterclockwise with a wrench.
Tightening torque : ...
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and fall with lower intensive light.
1. Battery2. LIN (Local Inter ...