Hyundai Genesis: SRSCM / Side Impact Sensor (SIS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and Operation

Description
The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors which are installed in the rear pillar (left and right).
The Front Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
The Rear Side Impact Sensor is also called G-SIS because it detects acceleration due to collision at its mounting location.
SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when collision occurrs.
Front Impact Sensor (FIS) Repair procedures
Removal     • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor co ...

Side Impact Sensor (SIS) Components and Components Location
Components ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Electric parking brake (EPB)


Applying the parking brake To apply the EPB (Electric Parking Brake): 1.Depress the brake pedal. 2.Pull up the EPB switch. Make sure the Parking Brake Warning Light comes on. Also, the EPB is applied automatically if the [AUTO HOLD] switch is on when the engine is turned off. Howeve ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Accelerator Pedal Repair procedures


Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting nut (C) after removing the top cap (B). 4. Remove the mounting bolt (E) after removing the Lower cap (D). Instal ...

© 2013-2025 www.hgenesisdh.com