Hyundai Genesis (DH): Fuel Delivery System / Accelerator Pedal Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the mounting nut (C) after removing the top cap (B).
4.
Remove the mounting bolt (E) after removing the Lower cap (D).

Installation
1.
To install, reverse the removal procedure.
Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Removal 1. Remove the filler neck mounting screws (A) after opening the fuel filler door. 2. Remove the rear-left wheel & tire and wheel house cover.

    Removal    

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Components and Components Location

    C

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0348